Notes on battery
• Do not attempt to charge a dry battery.
2-666-811-21(1)
Troubleshooting
Installing the Battery
(See Fig. A)
• Do not carry a dry battery together with coins or other metallic objects. It can
generate heat if the positive and negative terminals of the battery are
accidentally come into contact with metallic objects.
• When you are not going to use the unit for a long time, remove the battery to
avoid damage from battery leakage and corrosion.
Should any problem persist after you have made the following checks, consult
your nearest Sony dealer.
FM Stereo PLL Synthesized
1 Open the battery compartment lid and install one size AAA (R03)
Very weak or interrupted sound, or unsatisfactory reception
• Weak battery.
• In a vehicle or in a building, move closer to a window.
Headphone Radio
battery (not supplied) observing correct polarity.
When a battery is first installed, “AM 12:00” flashes in the display. Once the
current time is set, the flashing stops.
Operating Instructions
There is hum or noise.
• If POWER is set to LOCAL, set to DX.
2 Close the lid.
A
Insert the E side of
the battery first.
“WALKMAN” is a registered trademark of Sony Corporation to represent Headphone Stereo
Noise occurs.
Battery Life (Approx. hours)
When using
(JEITA*)
products.
is a registered trademark of Sony Corporation.
• Ensure that the unit is not near a mobile phone or any other device that emits
radio waves.
FM
30
FM WALKMAN
Printed on 100% recycled paper using
VOC (Volatile Organic Compound)-
free vegetable oil based ink.
Sony alkaline size AAA (LR03)
Sony size AAA (R03)
Display is dim, or no indication is displayed.
• Weak battery.
• The unit is being used in extremely high or low temperatures or in a place with
excessive moisture.
11
SRF-HM10
g
© 2006 Sony Corporation
Printed in China
* Measured by JEITA (Japan Electronics and Information Technology Industries
Association) standards. The actual battery life may vary depending on the
circumstance of the unit.
The station cannot be received when a preset is tuned.
• You chose the wrong preset number.
• The memory of the station has been initialized. Preset the station again.
Size AAA
(R03) × 1
When to replace the battery
You can check the remaining battery power that appears in the display. The
indicators are as follows:
The power cannot be turned on, and “
display.
” is flashing in the
• The battery has been completely exhausted.
For customers who purchased this product in the USA
Please register this product on line at
Proper registration will enable us to send you periodic mailings about new
products, services, and other important announcements.
Registering your product will also allow us to contact you in the unlikely
event that the product needs adjustment or modification. Thank you.
Indicator
The preset stations may be initialized, if a maintenance service is performed.
Please note down your settings in case you want to preset them again.
Full strength*
x
Weakening*
x
Specifications
When the battery becomes exhausted, the unit will turn off. Replace
with a new battery. When you set POWER to ON after installing the
Time display
WARNING
12-hour system
Frequency range
new battery, the indicator changes to “
* Displayed only when the radio is turned on.
Note
Do not take more than 30 seconds to replace the battery, otherwise, your clock
and preset stations will be initialized. Should this happen, reset the functions
again.
”.
You are cautioned that any changes or modifications not expressly approved
in this manual could void your authority to operate this equipment.
Band
Range
Channel step
FM
87.5 – 108 MHz
0.1 MHz
This device complies with the Part 15 of the FCC Rules.
Operation is subject to the condition that this device does not cause harmful
interference.
Power output
4 mW + 4 mW (at 10 % harmonic distortion)
Headphone type
Closed, dynamic
Power requirements
1.5 V DC, one size AAA (R03) battery
Mass
Approx. 63.8 g (2.3 oz.) incl. battery
Supplied accessories
Earbuds (S × 2, L × 2)
Features
• PLL (phase locked loop) synthesized tuning radio.
• Water-resistant for all –weather use.
• MEGA BASS for dynamic bass sound.
• 15 stations can be preset.
Design and specifications are subject to change without notice.
Precautions
Lead-free solder is used for soldering.
Halogenated flame retardants are not used in printed wiring boards.
• Operate the unit only on 1.5 V DC with one size AAA (R03) battery.
• Avoid exposure to temperature extremes, direct sunlight, moisture, sand, dust
or mechanical shock. Never leave the unit in a car parked under the sun.
• Should anything fall into the unit, remove the battery and have the unit checked
by qualified personnel before operating any further.
• To clean the casing, use a soft cloth dampened with a mild detergent solution.
• In vehicles or buildings, radio reception may be difficult or noisy. Try listening
near a window.
• If the Driver units become wet, wipe them with a dry towel before use.
• Clean the earbuds by hand-washing with a mild detergent solution. Remove the
earbuds when you clean them. After cleaning, dry the earbuds well before use.
Notes on Headphones
Road safety
Do not use headphones while driving, cycling, or operating any motorized
vehicle. It may create a traffic hazard and is illegal in many areas. It can also be
potentially dangerous to play your headphones at high volume while walking,
especially at pedestrian crossings. You should exercise extreme caution or
discontinue use in potentially hazardous situations.
Preventing hearing damage
Avoid using headphones at high volume.
Hearing experts advise against continuous, loud and extended play. If you
experience a ringing in your ears, reduce volume or discontinue use.
Caring for others
Keep the volume at a moderate level. This will allow you to hear outside sounds
and to be considerate to people around you.
Warning
If there is lightning when you are using the unit, take off the headphones
immediately.
Cautions on Water-Resistance
This unit is designed so that it can be used with slight exposure to rain, snow and
other forms of moisture, but there are several points on which caution should be
observed.
• Do not allow it to come in contact with large amounts of water.
• Do not immerse it in water.
• If water should get on it or if it should fall into water, take it out immediately
and wipe it off with a dry cloth. The interior of the battery compartment
has no water-resistance. The battery may corrode, so wipe out the interior
of the battery compartment as follows.
– Open or close the battery compartment with dry hands in a place without
exposure to any water.
– Wipe off the battery and the inside of the battery compartment. Give special
attention to the contacts, so that no water remains on them.
If you have any questions or problems concerning your unit, please
consult your nearest Sony dealer.
|