3.2 CU.FT. DOUBLE DOOR
RIFRIGERATOR
USER MANUAL
Model #: RF-322SS (Stainless Steel)
Model #: RF-322W (White)
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or
electrical shock.
Before you move your refrigerator into its final location, it is important to make sure you
have the proper electrical connection.
Recommended Grounding Method
This unit is applied with power supply of single-phase alternating current of 115V~,
60Hz. This appliance is equipped with a 3-prong (grounding) plug which mates with a
standard 3-prong wall outlet. DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD. Unit should
be plugged in a dedicated outlet.
Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or replacing a light bulb, turn
the refrigerator control to OFF and disconnect the refrigerator from electrical source.
When finished, reconnect the refrigerator to the electrical source and reset the control to
the desired setting.
LEVELING
If the refrigerator is not leveled during installation, the doors may not close or seal
properly, causing cooling, frost, or moisture problems. It is very important that the
refrigerator is leveled in order to function properly.
To level your refrigerator, turn the level leg clockwise to raise or turn counter-clockwise
to lower.
NOTE: Having someone push and tilt the unit backwards to take some weight off the
leveling leg will make adjustment easier.
3
2
1. Freezer Door
2. Refrigerator Door
3. Leveling Feet
4
1.Freezer Compartment
2.Thermostat
3.Light Bulb (Behind Thermostat)
4.Shelf
5.Refrigerator Compartment
6.Crisper Drawer
7.Small Rack
8.Can Storage
9.Bottle/Carton Storage
5
USING YOUR REFRIGERATOR
To obtain the best possible results form your refrigerator, it is important that you operate
it properly.
THERMOSTAT CONTROL
The thermostat for both the refrigerator and freezer is located at the upper right hand
corner inside the refrigerator compartment. The thermostat has a total of 7 settings,
from 1 to 6 (1 = least cold / 6 = coldest) and OFF.
The first time you turn the unit on, adjust the
temperature control knob to 3 and give your
refrigerator time to cool down completely before
adding food; a full 24 hours is recommended.
After it is fully cooled, test and adjust accordingly.
Turn dial towards 1 for less cool setting or towards 6
for colder setting. Setting the thermostat at 3 is
recommended for general home or office use.
DEFROSTING
Refrigerator compartment (Automatic defrosting):
•
Melted frost will flow into drip tray for automatic evaporating.
Freezer compartment (Manual defrosting):
• Turn the thermostat knob to OFF position and leave
the freezer door open.
• Remove ice cube tray and shelf. Transfer all food to
another freezer unit or to the refrigerating
compartment.
• Clean and wipe the melted frost with a cloth.
• After defrosting, turn thermostat knob to original
position.
Note: To avoid damaging the freezing compartment wall, do not use any sharp objects
or tools to remove the frost or separate frozen food.
6
CHANGING THE LIGHT BULB
1. Unplug refrigerator or disconnect refrigerator from power supply before you remove
the light bulb.
2. Unscrew the middle and lower parts of the
thermostat holder assembly, marked by
arrows in the diagram.
3. Pull the light bulb cover (Thermostat holder
assembly) outward to remove it.
4. Unscrew the light bulb.
5. Replace with a 15-watt 120V appliance bulb
only. Not all bulbs will fit your refrigerator. Be
sure to replace bulb with the same type (E-12)
and shape. The bulb T6 can be used.
6. Reconnect refrigerator to power supply.
POWER INTERRUPTIONS
When the electricity in your house goes out:
•
•
For a short period, keep both doors closed to help food stay cold and frozen.
For a long period, it is recommended to transfer your food to a different refrigerating
unit with power; or keep both doors closed.
FRESH FOOD STORAGE
Food stored in the refrigerator should be well wrapped or stored in airtight containers.
This will help prevent odor and taste transfer.
•
•
Fruit: wash, dry and store in refrigerator in plastic bag or in the crisper.
Leafy vegetables: Remove wrapping and trim/tear off bruised and discolored
sections. Wash in cold water and drain. Place in plastic bag or plastic container and
store in crisper.
•
•
•
Fish: It is recommended to use fresh fish the same day it is purchased. To
refrigerate, wrap securely or store in airtight container.
Meat: It is okay to store meat in original wrapping as long as it is airtight and
moisture-proof. Rewrap if necessary.
Leftovers: Cover leftovers with plastic wrap or aluminum foil. Or store in airtight
containers.
7
FROZEN FOOD STORAGE
The freezer compartment is designed for storing frozen food or freezing food at home.
Successful freezing depends on proper packaging. When you close and seal the
package you must not allow air or moisture in or out. If you do, you could have food odor
and taste transfer and also dried-out frozen food.
Note: Never put bottled food or drinks in the freezer compartment.
Note: For best performance, leave enough space in the freezer and refrigerator
compartment for air to circulate around the packages. Also leave enough room at the
front so the door can close tightly.
MAINTAINNG YOUR REFRIGERATOR
The refrigerator should be clean at least once a month to prevent odors form building
up. Wipe up spills immediately.
•
•
•
Turn thermostat control to OFF position and unplug from power source.
Remove all movable parts, such as shelves, crisp drawer, etc.
Use a clean sponge or soft cloth soaked in a mild detergent and warm water
solution. Do not use abrasive or harsh cleaners.
•
•
Hand wash, rinse and dry all surfaces thoroughly.
Do not use cleaning wax, concentrated detergent, bleach or cleaners containing
petroleum on plastic and rubber parts.
•
Never use paper towel, window spray, scouring pad or flammable fluid on plastic
parts as these can scratch or damage the material.
TROUBLESHOOTING
In case of malfunction, you can solve many common problems easily.
Your refrigerator will not operate…Check if
•
•
The power supply cord is unplugged.
The thermostat knob is set to OFF position.
The light does not come on…Check if
•
•
•
•
The power supply cord is unplugged.
Household fuse or circuit breaker has tripped.
Light bulb is loose in the socket.
Light bulb has burned out.
8
Food in the refrigerator compartment freezing…Check if
•
•
The thermostat knob is set too cold.
The food is touching the refrigerant power at the back wall.
Food in the refrigerator compartment is not cold…Check if
•
•
•
•
The air vents are blocked, which prevents the movement of cold air.
The door(s) are opened too frequently or not closed properly.
A large amount of food has just been added.
The thermostat is set too low.
Melted frost leaks inside the compartment inside or onto floor…Check if
•
•
The drain sprout is blocked.
Evaporator pan is in place.
The refrigerator seems to make unusual noise…Check if
•
•
•
The refrigerator is leveled on the floor.
The body of the refrigerator is touching the wall.
The drip tray is placed properly.
There is interior moisture build-up…Check if
•
•
•
•
•
The air vents are blocked in the refrigerator.
The door is opened frequently.
The room is humid.
The food is not packaged properly.
The control is not set correctly to the surrounding conditions.
The doors will not close completely…Check if
•
•
•
•
Food packages are blocking the door.
The shelves are out of position
The gaskets are dirty.
The refrigerator is leveled.
REQUESTING ASSISTANCE OR SERVICE
If the problem is not due to one of the items listed in Troubleshooting, Contact
Sunpentown customer service at 800.330.0388.
9
Your Guarantee
If this product is found to be faulty as a result of faulty materials or workmanship within
one year from date of purchase, it will be repaired free of charge.
This guarantee is subject to the following terms:
•
•
•
Sunpentown must be notified of the fault.
Proof of purchase must be presented to Sunpentown’s nominated representative.
The warranty will be void if the product if modified, misused or repaired by an unauthorized
person.
•
•
•
•
The warranty after repair will not be extended beyond the original one-year period.
All replacement parts will be new or reconditioned.
Parts, which are replaced, become the property of Sunpentown.
The warranty applies for the use of the product in the USA only.
What is NOT COVERED:
•
•
•
Warranty does not include freight charges.
Incidental or consequential damage caused by possible defects with this product.
Damage to product caused by improper power supply voltage, accident, fire, floods or acts of
nature.
•
•
Failure of product resulting from unauthorized modifications to the product.
Improper installation or failure to perform the necessary maintenance.
This GUARANTEE is in addition to your Statutory Rights
SUNPENTOWN INTERNATIONAL INC.
21415 Baker Parkway, City of Industry, CA 91789-5236
Tel: 909-468-5288 · Fax: 909-468-5279
10
|